Anything is possible. Whether floor, wall, ceiling or pillars.

A small selection of typical application areas is:
bathrooms, hallways, stairs, swimming-pools and more!

Company logos, family-crest, crest for clubs or heraldic figures are also available on request ....

Thanks to the prefabrication of the mosaic on mats, each tile and every bit the skillful craftsmen like normal mosaic tiles embarrassed.

You need to Route: materials: marble acid free glue, joint filler in the color of your choice, impregnation or stone in the gloss of your choice (shiny, silky, matt) tools: rubber gloves, brush, tooth scraper, bucket, sponge, plaster board and for the laying on Ground a piece of wood approximately 32cm x 32cm (5mm plywood, etc.) All materials are in good DIY retailers or available

The stones are natural pebbles in expert processing, there is no risk of the pebble mats out to use it outside. Basically the tiles are properly impregnated with the appropriate glue for outdoor and waterproof joints and fillers to be processed. The publishing and especially the filling of the joints should be very carefully done, the soil should then also be regularly waxed (acid-free use wax), a penetration of moisture in and under the tiles to be avoided

Of course. The tiles must be very carefully and regularly re-impregnated to be an adhesion of dirt or fat be avoided. The same applies to areas where you use harsh cleaners, for example in the shower.

The dispatch our goods is usually done by forwarding services. The amount of shipping depends on the order quantity and delivery.

Basically, we advise to contact an expert on the subject beforehand and to clarify whether that he have experienced in dealing with natural stone mosaics has. You can, of course - with some skill - the tiles themselves embarrassed.
First, the ground floor. Then prepare the glue (adhesive) in according to instructions and touched with a dental scraper on a clean, flat surface.
Insert the tile on wooden boards, put the edge of the tile to the wall, hold the tile and then drag the boards under the tiles away. Now press the tile with your hand and a plaster-board in the right place. After depositing clean the tiles immediately with a damp sponge. Any remnants of the glue on the surface of the tiles have to be removed.
After complete hardening of the glue (adhesive), the joint filler and the surface of the stones have to be washed clean.
Once the tiles are dried, you must them treated with an individual tile or stone impregnation. Only after this part you are able to silicon the tiles-parts.
After complete drying of the tiles you should complete the ground with an impregnation sealed. This has the advantage, if for example, once red wine, cola or water from a flower-vase should be buried, that it is not equal to penetrate into the tiles. You have searched for the impregnation of protection for many years.